Greddy TURBO KITS: Mazda RX-8 2003 / T618Z Manual de usuario

GReddy Turbo Kit 2003 Mazda RX-8 (13B-MSP) T618Z 10cm2 (Actuator Type) Emanage Ultimate

3-3 Oil Pressure Line Installation 1. Remove the factory oil pressure switch at the left side of the rear rotor housing and install the Oil pressure

5. Connect the oil pressure line that was installed in the step 3-2 to the turbocharger. Install the turbocharger to the manifold using the provided

3-5 Intercooler Installation 1. Remove the auxiliary temp sensor on the bumper reinforcement, and rotate it 180°, then reinstall it back to the origi

6. Secure C-5 bracket to the speed sensor harness bracket (LH). (Parts Used #11, 12, 13, 34, 35, 37, 41, 42, 56) 7. Reinstall the front stabili

4. Assemble the Airinx back together and hand tight the top screw. 5. Remove the factory Airflow meter off from the air cleaner box and install the

2. Install the O2 sensor to the down pipe adapter and install the adapter to the Turbo using provided gasket and hardware. Connect the O2 sensor co

3-8 e-manage Ultimate installation and vacuum hose connection for the actuator. 1. Remove the washer tank and drill a 1" hole on the fire wall.

3-9 Bumper installation 1. Cut the under cover and the inner fender cover to clear the compression pipe. 2. Reinstall the front bumper.

Starting the Engine 1. Reinstall the battery tray, battery box, battery, and connect the positive terminal only. 2. Reinstall the front strut tower

2003 Mazda RX-8 (13B-MSP)T618Z 10cm2 (Actuator Type) Installation Manual Please read the entire manual before installing this kit. Application:

1. Parts List 1. Turbocharger T618Z 10cm2 P380 1 2. Exhaust Manifold Ductile Iron Cast 1 3. Downpipe Adapter

36. Silicone Hose 50∅ - 60∅ Reducer 1 37. “ 80∅ x 80∅ Reducer 1 38. “ 80∅ - 90∅ Reducer

Part List 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24~26 27

28 29 30~32 33~35 36~38 39~43 44 45 46 47 48 49 50, 51 52, 53 54~56 57 58 59 60 61

2. Factory Parts Removal When removing the stock parts, please refer to the factory RX8 Workshop manual for proper procedures. 2-1 Factory Parts Re

3. Turbo Kit Installation 3-1 Intake Manifold Plate Installation 1. Remove the extension manifold (upper). Please refer to RX8 worksho