Greddy AIR INTAKE SYSTEMS: Honda Accord 4cyl. 2008-12 Manual de usuario

Busca en linea o descarga Manual de usuario para Para El Coche Greddy AIR INTAKE SYSTEMS: Honda Accord 4cyl. 2008-12. GReddy AIR INTAKE SYSTEMS: Honda Accord 4cyl. 2008-12 User Manual [it] Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 2
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Installation
Kit P/N:
12559003
Make:
Honda
Model: Year: Engine:
Accord ’08-’12 L4-2.4L
1
Complete Stock intake. Please disconnect battery
terminals before installation. Do not attempt to install
kit if vehicle is not cold!
2
Disconnect MAF sensor harness. With Phillips or
10mm socket or wrench loosen both clamps on intake
tube.
3
Remove crank case line attached with throttle body
coolant line. Have a shop towel or rag handy to catch
any leaking coolant. Use pliers to remove both lines.
Save small clamps for later install.
Caution: Coolant may leak from line when removing!
7
Replace throttle body coolant line with 5/16” hose
provided and secure with clamps used from step 7.
8
Remove MAF sensor from stock air box using phillips
screwdriver.
9
With pliers remove crank case line from intake tube.
4
Un-clip upper half of air box and remove stock intake.
5
Loosen bolt securing in bottom half of air box using
10mm socket or wrench and remove along with air
filter.
6
06-80500 Pg1
Parts Identification:
1 Air filter (
61-90131)
1 Intake tube, 05-T1001P1
1 Coupling, elbow 05-00136
2 Clamp #048
1 5/8” hose @ 6”L
1 5/16” hose @ 7”L
1 Isolation mount M6
1 Flat washer M6
1 Nut M6
2 Screw M4 x .7 x 8
Tools Required:
10mm socket or wrench
Ratchet w/ extension
Phillips screw driver
Flat head screw driver
5/16” nut driver
Pliers
Note: Perform install only when
engine is cool. Read instructions
before installation and have
tools ready.
Vista de pagina 0
1 2

Indice de contenidos

Pagina 1 - Installation

InstallationKit P/N:12559003Make:HondaModel: Year: Engine:Accord ’08-’12 L4-2.4L1Complete Stock intake. Please disconnect batteryterminals before inst

Pagina 2 - Accessories

Install MAF sensor to intake tube using provided M4screws. 10Install air filter to intake tube and tighten using 5/16” nutdriver.11Install elb

Comentarios a estos manuales

Sin comentarios