Greddy AIR INTAKE SYSTEMS: Honda Accord 4cyl. 2008-12 (L) Manual de usuario

Instruction Manual P/N: 12559006Make: Honda Model: Accord Year: 2008-2012 Engine: L4-2.4L

Refer to Figure G for steps 20-21Step 20: Align the bracket with the factory hole and fasten with the M6 hex bolt M and washer JStep 21: Once the

Page 11Refer to Figure H for steps 22-23Step 22: Place the filter A onto the intake tube and tighten with a nut driver. Be sure not to over tighten

Refer to Figure I for step 24-25Step 24: Connect the 5/8” hose G from the primary intake tube to the crank case. Step 25: Plug the harness back in

Page 13Step 26: Instead of using the isolation mount used on the cold air intake install, attach directly to the body of the vehicle using the hex

Pro DRY S Air FilterTo purchase any of the items above, view airflow charts, dyno graphs, photos, and video; please go to GReddy.com.Page 14P/N: TF-901

Page 15GReddy.com

P/N: 06-80612GReddy Performance Products9 Vanderbilt, Irvine CA 92618TEL: 949.588.8300 • E-Mail:[email protected]

Label Qty. Description Part NumberA 1 Pro Dry S Air Filter TF-9011DB 1 Primary Intake Tube 05-T1001P2C 1 Secondary Intake Tube 05-T1001P3D

ABCDFEGHIJPage 3K LMNGReddy.com

Refer to Figure A for steps 1-7Step 1: Unplug MAS harness 1 from the stock intake systemStep 2: Unplug the vacuum line 2 from the stock intake

Refer to Figure B for steps 8-9Step 8: The metal plenum has a top and bottom. The top is vacuum from the OE intake tube to the crank case. The bottom

Refer to Figure C for steps 10-13Step 10: Loosely place the clamps F on the coupler elbow D and place onto throttle bodyStep 11: Screw on the

Refer to Figure D for step 14-15Step 14: To remove the front bumper, remove the 7 clips in the white circles aboveStep 15: Remove the screw on each si

Refer to Figure E for step 16-17 (countinue for cold air install or skip to step 26 for short ram install)Step 16: Remove the 12 clips marked in whit

Page 9Refer to Figure F for step 18-19Step 18: Place the (2) clamps F onto the hump coupler E and place onto top of secondary intake tube C